Good cutting quality Because the laser spot is small, the energy density is high, and the cutting speed is fast, good cutting quality can be obtained.
The slit is narrow, and the slit for laser cutting is generally 0.10～0.20mm, saving material.
The edge of the kerf is good in verticality, the cutting surface is smooth and burr-free, and the surface roughness is generally controlled above Ra: 12.5.
The heat affected zone is small: the laser processing laser slit is fine, fast and energy concentrated, so the heat transferred to the material to be cut is small, and the deformation of the material is also very small. In some occasions, the heat affected zone width is Below 0.05mm.
It can cut a variety of materials, both cutting metal materials and cutting various non-metallic materials.
When cutting, the torch and the like have no contact with the workpiece, and there is no wear problem of the tool, and it is easy to realize automatic control without unmanned, and improve cutting efficiency.
Good cutting environment without strong radiation, noise and environmental pollution when cutting, creating a good workplace for the operator's health.
Ceramic ceramics, ceramic capacitors, ceramics for sensitive ceramics, ceramic fiber optic connectors and other functional ceramic products; ceramic knives, ceramic bearings, ceramic seal rings, ceramic spark plugs required by the machinery industry, roller kiln ceramic roller rods required by the building materials industry Structural ceramic products such as ball valves and cylinder liners required for the petrochemical industry; special ceramic materials required by the national defense industry; ecological environment ceramic materials and biomedical ceramic materials required for environmental protection. (cutting, drawing lines)